Physical Description
12
GS516TP Gigabit PoE Smart Switch
The following figure illustrates the smart switch back panel.
Figure 2. Back panel
The back panel contains a power connector.
LED Designations
This section describes the designations of the LEDs found in the front panel of the smart
switch.
Port LEDs
The following table describes the RJ-45 port Link/ACT and PoE port status LED
designations.
Table 2-1. Port LEDs
LED Designation
Link/ACT LED mode for copper
ports 1–16
Link/ACT Mode LED:
• Off. No link is established.
• Solid green . A valid 1000 Mbps link is established.
• Blinking green. The port is transmitting or receiving packets at
1000
Mbps.
• Solid yellow . A valid 10/100 Mbps link is established.
• Blinking yellow . The port is transmitting or receiving packets
at
10/100 Mbps.
PoE Status LED for PoE ports
1–8
• Off . No PoE powered device (PD) is connected.
• Solid green . The PoE powered device (PD) is connected and the
port is supplying power successfully.
• Solid yellow . Indicates that one of the following failures resulted in
stopping power to that port:
- There is a short circuit on PoE power circuit.
- The PoE power demand exceeds power available.
- The PoE current exceeds PD’s classification.
- The supplied power is out of proper voltage band (44–57 VDC).
Power connector
Commenti su questo manuale