Netgear ProSafe FSM7352S Manuale Utente

© 2005 by NETGEAR, Inc. All rights reserved. Trademarks © 2005 NETGEAR, Inc. NETGEAR ® , the Netgear Logo, the Gear Guy, and Everybody’s connecting a

establish a link with non-stacking interfaces no traffic will pass across the interface. These interfaces are available to quickly and easily build a

LED Descriptions The front panel of the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch has LEDs that provide a quick and accura

The console port is configured to use the following settings: • Baud rate: 9,600 bps • Data bits: 8 • Parity: none • Stop bit: 1 • Flow control:

CHAPTER 3: INSTALLATION This chapter describes the installation procedures for your NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Sw

Step 2: Installing the Switch You can install your NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch on a flat surface or in a sta

1. Connect the female end of the supplied AC power adapter cable to the power receptacle on the back of the switch. 2. Connect the 3-pronged end of

To install additional Gigabit Ethernet module, repeat this procedure Figure 3-3. Installing a Gigabit Ethernet fiber Module into an FSM7352S St

Figure 3-4. System Information. 5. The login name is “admin”. And there is no password assigned. We strongly recommend you enable password for admi

Sysinfo page. To use your web browser, simply type the IP address in the URL address bar and hit enter. If you want to use an SNMP management applic

APPENDIX A: TECHNICAL SPECIFICATIONS This appendix provides technical specifications for the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Eth

Warning: This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to t

Secured Shell (SSHv1,v2) Interface 48 RJ-45 connectors for 10BASE-T and 100BASE-TX (Auto Uplink™ on all ports) 4 RJ-45 connectors for 10BASE-T, 100B

EN 55024 Safety CE mark, commercial CSA certified (CSA 22.2 #950) UL listed (UL 1950)/cUL IEC950/EN60950 Page 21 of 24

APPENDIX B: TROUBLESHOOTING This chapter provides information about troubleshooting the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet

Configuration If problems occur after altering the network configuration, restore the original connections and determine the problem by implementing t

APPENDIX C: Default Settings This appendix provides the default settings for the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switc

CONTENTS CHAPTER 1: INTRODUCTION...

Figures FIGURE 1-1. PACKAGE CONTENTS...

CHAPTER 1: INTRODUCTION Congratulations on your purchase of a NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch! Your NETGEAR Swit

Features The following list identifies the key features of the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch. • Forty-eight 1

o Full-duplex IEEE 802.3x pause frame flow control • Multiple interfaces to access the management features o Browser-based Graphical User Interface

Figure 1-1. Package Contents Verify that your package contains the following: FSM7352S Layer 3 Managed Stackable Fast Ethernet Switch Rubber foot

CHAPTER 2: PHYSICAL DESCRIPTION This chapter describes the hardware features of the NETGEAR Model FSM7352S Layer 3 Managed Stackable Fast Ethernet Swi