Netgear Switch M4100 Manuale Utente Scaricare il pdf (Pagina 191)

100

101

Chapter 11. CoS Queuing | 191

ProSafe M4100 and M7100 Managed Switches

CoS Queue Mapping

CoS queue mapping uses trusted and untrusted ports.

Trusted Ports

• The system takes at face value certain priority designations for arriving packets.

• Trust applies only to packets that have that trust information.

• There can be only one trust field at a time - per port.

- 802.1p user priority (This is the default trust mode and is managed through switching

configuration.)

- IP precedence

- IP DiffServ Code Point (DSCP)

The system can assign the service level based upon the 802.1p priority field of the L2

header. You configure this by mapping the 802.1p priorities to one of three traffic class

queues. These queues are:

• Queue 2. Minimum of 50 percent of available bandwidth

• Queue 1. Minimum of 33 percent of available bandwidth

• Queue 0. Lowest priority, minimum of 17 percent of available bandwidth

For untagged traffic, you can specify the default 802.1p priority on a per-port basis.

Untrusted Ports

• No incoming packet priority designation is trusted; therefore, the default priority value for

the port is used.

• All ingress packets from untrusted ports, where the packet is classified by an ACL or a

DiffServ policy, are directed to specific CoS queues on the appropriate egress port. That

specific CoS queue is determined by either the default priority of the port or a DiffServ or

ACL-assigned queue attribute.

• Used when trusted port mapping is unable to be honored - for instance, when a non-IP

DSCP packet arrives at a port configured to trust IP DSCP.

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 558 559

Commenti su questo manuale

Nessun commento

Netgear Switch M4100 Manuale Utente Pagina 191

Commenti su questo manuale

Prodotti e manuali riguardandi Networking Netgear Switch M4100