Netgear WG311T Manuale Utente Scaricare il pdf (Pagina 42)

NETGEAR 108 Mbps Wireless PCI Adapter WG311T User Manual

3-2

v5.0, January 2007

The Smart Wizard keeps asking me to save

settings.

If you change the settings the Smart Wizard offers you the

chance to save the changes. To avoid this prompt, simply click

Apply before you close the Smart Wizard.

Two WG311T icons are in the system tray. You have an older software version installed on your system

and it needs to be removed. See “Removing the WG311T

Software” in Chapter 1 or “Upgrading the WG311T Software”

in Chapter 1.

I can connect to the access point, but not

the other computers on the network or to

the Internet.

This could be a physical layer problem or a network

configuration problem.

1. Check to make sure that the access point is physically

connected to the Ethernet network.

2. Make sure that the IP addresses and the Windows

networking parameters are all configured correctly. See

the link to “Internet Networking and TCP/IP Addressing:” in

Appendix B, “Related Documents”

3. Restart the cable or DSL modem, router, access point, and

computer.

Viewing the IP address. To view the WG311T Wireless PCI Adapter IP address, click

the WG311T icon to open the Smart Wizard. Then check the

IP address in the About page.

No IP address is assigned to the WG311T

Wireless PCI Adapter.

This may occur if you upgraded your WG311T Wireless PCI

Adapter software and did not reboot your system.

• Either restart your computer, or connect to a different access

point.

• It does not usually help to shut down the Smart Wizard or

disable/enable the card.

Table 3-1. Troubleshooting Tips (continued)

Problem Action

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Nessun commento

Netgear WG311T Manuale Utente Pagina 42