Netgear XSM7224S Manuale Utente Pagina 133

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 579
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 132
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-92
v1.0, November 2010
storm-control unicast level (Global)
This command configures the unicast storm recovery threshold for all interfaces as a percentage of
link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate
of unknown unicast traffic will be limited to the configured threshold.
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables unicast
storm recovery for all interfaces.
storm-control unicast rate (Global)
Use this command to configure the unicast storm recovery threshold for all interfaces in packets
per second. If the mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped.
Therefore, the rate of unicast traffic is limited to the configured threshold.
Format no storm-control unicast
Mode Global Config
Default 5
Format storm-control unicast level <0-100>
Mode Global Config
Format no storm-control unicast level
Mode Global Config
Default 0
Format storm-control unicast rate <0-14880000>
Mode Global Config
Vedere la pagina 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 578 579

Commenti su questo manuale

Nessun commento